| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-31-2007, 08:40 AM
| |||
| |||
I just obtained a 4 pole 24volt DC 16.5 amp motor, 300 watt ( Scooter part) and speed controller. RPM is rated at 2750 The Idea is to drive a spindle on my Gantry router/Engraver. Can I control the speed from MACH3 and if so how could this be done. I intend to use this to mill small ALI parts with 6mm and 8mm cutters. I find that a normal router spindle is too fast and way too noisy. Any comment and suggestions welcome Bill Files
__________________ The More I Learn The Less I Seem To Know  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Infotec 2015 Query | s1j1m10 | Commercial CNC Wood Routers | 0 | 03-15-2007 12:03 PM |
| Tapping Query | SPEEDRE | General Metalwork Discussion | 14 | 12-20-2006 07:05 PM |
| Yet Another Bearing Query... | itsme | Mechanical Calculations/Engineering Design | 2 | 12-18-2006 05:42 PM |
| Software Query | Otacustes | General CAM Discussion | 0 | 07-09-2006 11:36 AM |
| Encoder Query | bean7795 | General Electronics Discussion | 2 | 04-28-2005 08:10 PM |
| | |
4 Ple DC Motors query 
Linear Mode
