Would love to hear about how quiet your servos are

[pointcloud]

Tell me what system you have and if there is a SERVO HUM.

If there noisy tell me how you tried tunning the servos and drives (amps).

I have heard that Gecko 320's make noise, even after tunning?

I think they should NOT allow the SERVOS to HUM loudly for sure...

EARS>>>>>>>>>>>>>>>>>>.

[Al_The_Man]

Originally Posted by pointcloud Tell me what system you have and if there is a SERVO HUM. If there noisy tell me how you tried tunning the servos and drives (amps). .

If a servo moves in the shop and there is no one there to hear it, does it make a noise.

I have two motion card systems, Galil and Acroloop, these run DC servo's and DCBL, AMC and Copley Controls.
There is no hum or buzz at all when stationary, I cannot detect any motor noise from the DC when running, the DCBL have a slight hi-pitch hum when running, A marked difference from the original velocity mode drives, (these are Torque mode drives).
Al.

[pointcloud]

I guessed more people had servos?

I was sure there was not to be any noise from the servo..

Thanks for the reply AL.
I have a galil and it too is quiet, I have geckos (320/340? not sure which), but there quiet too..