| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-12-2007, 12:47 PM
| |||
| |||
Hi, I picked up a couple of CMD-260 Bipolar Microstep Chopper Stepper Drives made by American Precision Industries (API) a couple of years ago and I'm finally getting around to trying to use them. I was looking for a parallel port breakout board and haven't found any that meet the driver's logic input requirements. They are specified to be +5VDC 100mA minimum. I've got 2 drivers so I suppose that means I need 200mA minimum. So if anyone has or is using these drives can indicate what they used to supply that much power for the logic I'd greatly appreciate it. Thanks, Andre  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AMC drives | ka67_72 | Servo Motors and Drives | 4 | 03-10-2007 06:38 AM |
| Help with drives | ltoy | Mach Mill | 1 | 11-15-2006 06:33 PM |
| Pac Sci Drives | George41 | Stepper Motors and Drives | 6 | 10-29-2006 04:24 PM |
| Zip Drives | Mortek | Haas Mills | 1 | 08-02-2006 02:42 AM |
| Can someone help me with these motor/drives, I think the drives are dodgy? | Darc | Stepper Motors and Drives | 1 | 07-23-2005 06:31 PM |
| | |
Linear Mode
