| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-02-2007, 08:02 PM
| |||
| |||
Just thought I'd pass this along. It's an "Off the Table Mouse" or "Finger Mouse". It works great to hit the Jog buttons while you're right at the machine. Takes a few minutes to get use to it, and then you can't live without it. They aren't optical, and can gum up, but pop out the ball and clean it up. I found these for under 10 bucks.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible jog pendant? | mrosso | Screen Layouts, Post Processors & Misc | 0 | 02-14-2007 03:09 PM |
| MPG pendant | troy676zsj | Fadal | 0 | 07-30-2006 09:15 PM |
| Pendant? | CNCadmin | Carken Products (Deskam, DeskCNC etc) | 2 | 01-10-2005 09:32 AM |
| Pendant? | CNCadmin | Carken Products (Deskam, DeskCNC etc) | 0 | 05-07-2004 09:10 AM |
| Cheap USB "Pendant" | vacpress | CNCzone Club House | 3 | 03-18-2004 02:06 PM |
| | |
Linear Mode
