| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-28-2007, 06:52 PM
| |||
| |||
I am running on an extremely tight budget for my first project. I have chosen my steppers, Nema23s with 57oz of power. I am trying to find a decent 2-axis driver for them but I haven't had much luck. I am looking between 50 and 60. I saw HCNC had their old 4-axis on clarance for 76 with shipping and their new 3-axis for 86 with shipping, but those are both a little too high. I did see the a100smc for 45 but they aren't available any longer.  |
|
#2
06-28-2007, 09:06 PM
| |||
| |||
| A 57oz stepper shouldn't require an expensive driver. Check out some of my favorite surplus electronics sites. I'll wager that you'll find a compatible stepper driver for less than 25 bucks. http://www.alltronics.com/ http://www.allelectronics.com/ http://www.goldmine-elec-products.com/departments.asp http://www.bgmicro.com/shop.asp |
|
#3
06-29-2007, 11:50 AM
| |||
| |||
Check out Gecko Drive at www.Geckdrive.com. ou can buy there stepper dirves for one axis only. also checkout a\the web site www.campbelldesigns.com. There is plenty of information about drive and control designs for the machine on a budget. Wood Image Lonnie |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A 5-axis CNC machine including a rotary axis | synthetiklone | CNC Wood Router Project Log | 11 | 05-23-2012 09:31 PM |
| the Difference of 2-Axis and 3-Axis of Vertical Mill Machine | begacon | Knee Vertical Mills | 6 | 07-30-2009 06:31 AM |
| New Design - Hybrid 3-Axis Router/4-axis Foam Hot Wire Cutter | the__extreme | CNC Wood Router Project Log | 3 | 02-26-2007 02:58 PM |
| Options for 2 Axis Head (to make 5 axis) | drewgarth | DIY-CNC Router Table Machines | 6 | 07-12-2006 12:37 AM |
| DIY CNC: Gallery for z-axis, y-axis etc designs | bigz1 | Suggestions for the CNCzone.com site. | 6 | 05-23-2006 01:46 AM |
| | |
Linear Mode
