| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-12-2007, 04:45 AM
| |||
| |||
Hello! I did make 3 single sided board from here and 2 of them works perfectly but one of them spin motor only in one direction. No matther what direction i chose. I'm using Mach3 and i cheched everything 3 times but still don't work. What is wrong and what could i do? Is my a3977 died? Sorry for my really bad english  |
|
#2
05-12-2007, 10:12 AM
| ||||
| ||||
| You proabably have a short on your pcb. I answer specific questions on that board on my forums.
__________________ Phil, Still too many interests, too many projects, and not enough time!!!!!!!! Vist my websites - http://pminmo.com & http://millpcbs.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor Troubles | tmd019 | Hobbycnc (Products) | 2 | 04-11-2007 08:34 AM |
| air troubles | wadetool | Haas Mills | 2 | 02-19-2007 03:30 PM |
| fanuc 0m-B troubles | sammer003 | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 01-25-2007 05:32 AM |
| DXF troubles | kung | G-Code Programing | 2 | 11-02-2005 03:41 PM |
| CAD Troubles | Blackhawk | General CAM Discussion | 27 | 06-11-2005 10:13 PM |
| | |
Linear Mode
