Parallel port controller - CNCzone.com-The Largest Machinist Community on the net!

szynszyl · #1 05-01-2007, 04:41 AM

Hi,
i'm looking for a supplier about lpt controller to use with driver as photos attached.
Do you have some suppliers name with good service support??
I prefer in Europe.

Thanks

belli · #2 05-01-2007, 12:13 PM

Hi szynszyl,

Have a look at www.leeuwinga.nl for a good LPT board that will work well with this application, it has complimentary outputs and supports up to 6 axis.

Ciao,
Greg

Leeuwinga · #3 05-01-2007, 02:14 PM

Originally Posted by szynszyl

Hi,
i'm looking for a supplier about lpt controller to use with driver as photos attached.
Do you have some suppliers name with good service support??
I prefer in Europe.

Thanks

I can supply you with a good interfacecard for Mach3.
Direct delivery from stock, with english manual.
see www.leeuwinga.nl

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Parallel Port machine controller to computer connection HELP PLEASE!	whipsnade	Machine Problems, Solutions , Wireless DNC, serial port	5	08-01-2006 04:45 PM
Second parallel port?	essa	LinuxCNC (formerly EMC2)	11	04-12-2006 02:18 AM
Parallel port	Aldoseri	BobCad-Cam	11	03-13-2006 10:10 AM
Parallel Port	Shanghyd	Computers and Networking	1	11-22-2004 11:56 AM
Controller parallel port connected via Ethernet (?)	WoodSnarfer	General Electronics Discussion	3	11-20-2004 03:48 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)