| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-30-2004, 10:59 PM
| ||||
| ||||
Hi all. Yet another DIY unipolar driver by VincenzoV from Italy. http://www.vincenzov.net/eng/design/unipolar.htm Comments are very welcome. I am looking at the schematic and cannot dig out if it uses pulse/dir or ... ? Konstantin. Edit: If you browse the Vincenzo website you are going to find more circuits to drive steppers, like http://www.vincenzov.net/eng/design/microstep.htm. And if you know italian then it would be easier  Last edited by Konstantin; 03-30-2004 at 11:37 PM.  |
|
#2
03-31-2004, 05:02 AM
| |||
| |||
| Konstantin, that driver is 'serial' and uses other board, the isobuffer (http://www.vincenzov.net/eng/design/isobuffer.htm) that hooks to the parallel port. It seems that the driving signals are 'full custom' and he uses LabView to generate them. From this, i do not expect compatibility with anything in the market  Fer |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 Axis Opto Isolated Interface board now up | pminmo | Open Source Controller Boards | 2 | 10-06-2005 05:12 PM |
| LPT Opto isolator Circuit Schematic | graphpix | General Electronics Discussion | 1 | 02-20-2005 04:13 PM |
| | |
Linear Mode
