Making a Relay with the PMDX-122 - CNCzone.com-The Largest Machinist Community on the net!

03-27-2007, 10:02 PM

Burn

Join Date: May 2006

Location: USA

Posts: 249

Making a Relay with the PMDX-122

permalink

The PMDX-122 (www.pmdx.com) can drive one relay. I need to turn on both my spindle and my flood coolant pump :\

http://www.cartertools.com/tbbrb.html

I am going to follow that article, my main question is this: Can I run both the spindle and the coolant pump off of 1 relay? Is that safe/reliable? Any thoughts would be appreciated.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Last minute purchasing decision- PMDX-122	Burn	Benchtop Machines	0	03-15-2007 04:11 PM
PMDX-122 BrakingBoard and MSD980 Driver	Goose80	Servo Motors and Drives	1	02-16-2007 05:58 PM
Debating between Mini-IO and PMDX Servo Drives for Taig	Burn	Taig Mills & Lathes	2	12-21-2006 09:54 PM
advice sofware with gecko 202 & pmdx board for mill	ajitsingh	Machines running Mach Software	2	08-10-2006 12:09 PM

All times are GMT -5. The time now is 04:41 AM.