Fuji Frenic 5000 - CNCzone.com-The Largest Machinist Community on the net!

hotrob1 · #1 03-21-2007, 12:16 PM

I'm in need of a 'hybrid module' marked BASELOG TM 3201 on it. It is out of a Fuji drive. The module is on the main board and the numbers off the board are EP 2248C and also has HAH30798 on it.

Does anyone have or know of a scrapped board or unit? I'll take something that is close. Could use this information rikki tick.

Re: Fuji Frenic 5000V (FSD 7AR-22)

Thanks.

-HOTROB1-

hotrob1 · #2 03-22-2007, 07:30 AM

Surely someone knows of a scrapped board or Fuji unit. I'll take something close. Trying to get this one repaired. The problem is the hybrid module on the main board. I'll take a main board if there is one available. Any help would be appreciated.

T.I.A.

hotrob1 · #3 03-22-2007, 01:13 PM

No one out there with any help or suggestions???

Thanks.

SGARCIAM · #4 08-20-2008, 06:22 PM

Did you find the Hybrid ?

damiens · #5 05-04-2009, 12:42 PM

FUJI no longer supports Fuji Frenic 5000V. As far as I know the only drives supported are FUJI FRENIC Mini, Eco, 5000G11S, 5000P11S, 5000VG7S & Multi series.

http://www.ctiautomation.net/FUJI-Inverters.htm

stevespain · #6 02-03-2010, 02:20 PM

need help, have frenic 5000 g11s drive unit am unable to access progam and only recieve ER1 on the display unit any suggestions

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fuji frenic v5000 spindle drive problem	zoeper	General Electronics Discussion	17	10-05-2011 06:55 PM
Fuji Spindle	wanchai101	Fanuc	1	07-12-2006 05:28 AM
Fuji Spindle Drive.	cncdiag	Fanuc	1	06-20-2006 10:59 AM
Fuji Inverter problem	flinty	Machine Problems, Solutions , Wireless DNC, serial port	4	11-10-2005 03:52 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)