| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-18-2007, 07:05 PM
| |||
| |||
Hi again ive just ripped a lexmark z11 printer apart and have these http://img403.imageshack.us/my.php?i...v200129oy9.jpg http://img143.imageshack.us/my.php?i...v200130ii5.jpg two stepper motors and the pcb that the motors are connected to allso with female printer cable conector and power socket.i may make a simple 2 axis just to draw eg left,right and then forward,backward with no up down i will attach a pen and make it draw pictures.will this board work could i program axis into it if so what software would i need. thanks all.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
