| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-13-2007, 09:44 AM
| |||
| |||
Hi, can anybody help me to wire this motor 86HY62DE04 (http://www.3xmotor.com/docc/cp9.htm) to 4XCNC10B from www.dtllc.com. Power supply don't start when motor is connected, so I think I made a mistake in wires connection. Regards.    |
|
#2
05-23-2007, 11:04 PM
| |||
| |||
Hello, I think you contacted me on this, the motor spec sheet looks familiar. I will post the answer here just in case and to help others with the same motors. YEL & BLU Twist together and attach to #1 resistor other end of resistor to motor power supply. PUE & BRN Twist together and attach to #2 resistor other end of resistor to motor power supply. RED to A on 4XCNC10B WHT to B on 4XCNC10B BLK to a on 4XCNC10B GRN to b on 4XCNC10B If you have any more questions feel free to contact me here: David Delagrange, Owner Delagrange Technology LLC 4024 Fairfield Avenue Fort Wayne, IN 46807 Phone: (260) 557-9280 Hours: Monday-Friday, 5:00 p.m.- 9:00 p.m. E-mail: admin@dtllc.com http://www.dtllc.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with motor stalling due to motor/lead screw alignment | Bimmerkc1 | DIY-CNC Router Table Machines | 3 | 01-24-2010 07:12 PM |
| | |
Linear Mode
