Centent cn0143 - CNCzone.com-The Largest Machinist Community on the net!

Cold Fusion · #1 03-15-2004, 08:53 AM

Anyone use this drive? I know someone that can get me a killer deal on 3 of these plus 214oz motors and a power supply.

http://www.centent.com/cn0142.htm

Mariss Freimanis · #2 03-15-2004, 12:18 PM

That is a blast from the past! I designed the CN0142/0143 back in the mid-80s. It is similar to the G201 in its ratings and has the same pin-out as the G201. Be careful not to go over its 60VDC rating or bad things will happen.

Mariss

Cold Fusion · #3 03-15-2004, 12:22 PM

So it's a decent driver? I plan to use it with 214oz Powermaxx 2.3amp motors. http://home.att.net/~fair451/ebay2/centent3drives.jpg

Mariss Freimanis · #4 03-15-2004, 12:50 PM

Should work very well.

Mariss

cnc2k · #5 07-16-2006, 06:20 PM

Mariss,
Do you have the math calcutlation for setting the current for CN0134? I'm using a 2.1 Bipolar(series) motor. The current setting chart has 3amp as the lowest.

Thank you for your help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)