| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-25-2007, 02:48 AM
| |||
| |||
I am using your using USB-I2cIO Rev: B3 Its 20 Bit I/O board connected to PC with USB (Using Cypress AN2131QC micro-controller) I am using this chip to interface OLD Turret Punch Press Machine V22NC The Problem occurs when three phase turret motor on (or some time off) for selecting tool (Either by My Chip or by manually) USB Chip’s controller restarts. Amazingly either nothing connect with chip give me same problem. I already try/Install following. It’s better but still facing same problem 1. Isolate Transformer 2. Proper Ground 3. Stabilizer 4. Take control (PC + USB CHIP + Driving chip etc) system away from machine. 5. Disconnect Driver chip (No Circuit connect with USB chip). Now we are tired to solve this problem. Now we are going to install AC noise filter. Please tell us Any Solution, tip or guideline to solve this problem?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with servo controller (G320) | faststeve | Gecko Drives | 19 | 04-03-2007 08:18 PM |
| haas floppy dnc restart | bytecolor | Haas Mills | 6 | 10-19-2006 07:31 AM |
| cnc controller problem | shadybacon | General CNC (Mill and Lathe) Control Software (NC) | 0 | 10-11-2006 08:07 AM |
| Problem with Bosch cc100 controller | yanjue | Machine Problems, Solutions , Wireless DNC, serial port | 0 | 09-23-2006 12:00 PM |
| | |
Controller Restart problem! 
Linear Mode
