| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-26-2004, 04:56 PM
| |||
| |||
I would like to know all the technical stuff about these. There is alot of jargon I don't know what it means or does. If someone could point me to a website that would be great. Thanks!!! Greg  |
|
#2
01-26-2004, 05:20 PM
| ||||
| ||||
| If you do a search for all that hardware you want information on, go to as many of the manufacturers web site's as you can, as a lot have not only have theoretical information, a few have free software for designing your system, amplifiers & motor sizes etc. a place to start would be www.electromate.com www.motionvillage.com www.motiononline.com, Do a search for incremental encoders and you should get a lot of encoder manuf. For specific questions, you can always ask here. Also try and get manufacturers free catalogue's, many have a wealth of technical data. Hope this helps. Al |
|
#4
03-31-2004, 12:43 AM
| ||||
| ||||
| GV71, That is my businness, if you ever need questions asked I will be happy to help you any way I can, feel free to PM me with questions.
__________________ "A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't" Greetings From Down Under Dave Drain Akela Australia Pty. Ltd. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport servos with Gecko drives | GalaticDan | Servo Motors and Drives | 0 | 03-17-2005 07:39 AM |
| Servos pausing and starting | InsaneEPP | Servo Drives | 9 | 03-15-2005 08:45 PM |
| newbie AC Servo question | GalaticDan | Servo Motors and Drives | 3 | 10-30-2004 11:25 PM |
| Servos, steppers, drives and encoders, Oh my | MobilDave | Servo Motors and Drives | 1 | 09-10-2004 07:04 AM |
| ? about servos with pics | gv71 | DIY-CNC Router Table Machines | 4 | 03-01-2004 08:42 AM |
| | |
servos (encoders, drives) 
Linear Mode
