Connecting FlashCut SG to Dyna 2400

[erazz]

Hello All,

I've got a Dyna 2400 mill with electronics that still works... Just.

I'm trying to connect a FlashCut Signal Generator to the stepper drivers of the Dyna. Not vey well so far.

Has anyone done this before?

I need the pinout for the FlashCut SG. Also the Pin-In (?) for the stepper drivers on the Dyna.

The Drivers connect with a 6 lead plug. Do you have any idea how this should wire?
One more, if I may... I need the signal requirement for the Dyna drivers. Things like leading or trailing, low or high, etc...

Thanks for any help you can give.
Erez.

[mp-]

Maybe you've already solved the problem, but in case you haven't I'll tell you what I've done.

I used the 'interface board' from an Ah-Ha cnc conversion kit, and simply plugged in the serial cable from the Flashcut signal generator. Works well.

Let me know if you have any questions about how to do this.

mp-