| | |
Does anyone have any info on the Micronor MR175 Handheld Pendant?
http://www.micronor.ch/content/pdf/manual/mr175.pdf
It looks nice, but I dont think 100 pulses per revolution is enough on the MPG. I'd have to turn it 200 times to move my stepper sytem one inch, and 20 times (more or less) for the servo system I'm building. There may be an easy way to multiply it, I dont know. Definately something to check out.
Halfnutz
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Depending on your Conroller software, you should be able to tell it how far to move for each pulse from the MPG.
You can do it with Mach3, I know for sure.
Andy
Posting Permissions
| | |
LinkBack URL
About LinkBacks
