| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
12-23-2003, 08:23 AM
| ||||
| ||||
Merry Christmas from Downunder! When I started looking at what controller to get, I was surprised to not find any set up for USB. There have been discussions RE: Using Parallel vs Serial and; how to "adapt" USB to Parallel then connect to a parallel board - but then I found: http://www.ar.com.au/~softmark/page44.html Softmark has heaps of respect in AUS/NZ as a good hobby project source - so during those long winters up in the Northern Hemisphere this might be a project for those interested. Certainly opens some new possibilities/opportunities! Merry Christmas  Jim  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Absolute cheapest Stepper Controller? | samualt | General Electronics Discussion | 14 | 05-25-2007 09:54 AM |
| Taig Mill, US Digital MS23, Controller??? | marjamar | Taig Mills & Lathes | 3 | 02-07-2007 09:16 AM |
| Stepper controller | itsme | General Electronics Discussion | 9 | 08-12-2004 11:30 PM |
| Anyone use this stepper controller? | mvaughn | DIY-CNC Router Table Machines | 0 | 03-18-2004 05:41 PM |
| | |
Linear Mode
