| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-08-2003, 02:26 PM
| |||
| |||
I've a control board from a broken, unkown scanner with a small (1.625") dc, seems to be 8 volt motor, thats works when plugged into the control board and wall wart, the only info available printed on a stick on label to the motor is as follows: EPOCH T42AF-MI 80828 Any info would be appreciated On a side note about the above board. This does have LPT input/output connections, does a scanner function the same and would this work for a stepper controller board? Thanks jerry  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New board help requested | pminmo | Open Source Controller Boards | 32 | 09-30-2008 05:10 AM |
| single sided A3977 board ( got files uploaded ) | tekno | Open Source Controller Boards | 170 | 01-27-2007 07:30 PM |
| New and need your help Please (driver board) | Oldmanandhistoy | General Electronics Discussion | 17 | 06-12-2005 04:48 PM |
| Hooking up HobbyCNC board and motors to PC... | jdbaker | Hobbycnc (Products) | 7 | 06-06-2005 01:10 PM |
| Running a parrallel interface board | Don C | DeskCNC Controller Board | 0 | 12-31-2004 04:45 PM |
| | |
Linear Mode
