| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-28-2006, 11:31 AM
| |||
| |||
I am relatively new to this forum and this is my first post. I have been reading up on as much as possible because I am building my first CNC router. I was wondering if someone can recommend a breakout board to me and any pros and cons. I am going to be using Gecko 212 drives and Mach3 software. Brian  |
|
#2
07-28-2006, 01:08 PM
| ||||
| ||||
| cnc4pc makes the C-10 breakout board. Highly recomended. Another poster here, Jerry, put this together. You may find it useful.
__________________ If you cut it to small you can always nail another piece on the end, but if you cut it to big... then what the hell you gonna do? Steven |
|
#3
07-28-2006, 01:15 PM
| ||||
| ||||
| This is actually Jerry Clark's newest diagram. The BOB he uses is the c-10
__________________ If you cut it to small you can always nail another piece on the end, but if you cut it to big... then what the hell you gonna do? Steven |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
