| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-27-2003, 06:18 PM
| |||
| |||
I hope I am in the right place??? I am lookig for help with a home built foam cutter and would like some guidance in choosing a 4 axis control for unipolar stepper motors. As this is being home bulit I would like to keep the cost as low as possible. Any and I mean ANY help would be very great full. The steppers I am using are 5volt 1amp .9degree steppers.    |
|
#2
10-27-2003, 06:41 PM
| ||||
| ||||
| Hi Flight, Hey, I'm from Saskatchewan, too. Small world, eh?  4 AXis? Check out the Camsoftcorp banner, or post a question in that section. I am supposing you need coordinated XY motion in 2 planes? Sounds a lot like wire edm requirements.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
10-27-2003, 07:12 PM
| ||||
| ||||
|
__________________ I wish it wouldn't crash. |
|
#4
10-27-2003, 08:24 PM
| |||
| |||
| Try this... www.8linx.com/cnc/cnc.htm |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where can I find Good CNC Wood Cutting machine for Car parts size ? | Calico | DIY-CNC Router Table Machines | 3 | 02-28-2005 12:36 AM |
| CNC router deflection calcs and cutting loads? | Linus | DIY-CNC Router Table Machines | 1 | 09-10-2004 11:08 AM |
| CNC For topo foam work | texasjeff | DIY-CNC Router Table Machines | 7 | 05-08-2004 10:14 AM |
| DXF2DAT 3.0 Professinal released (cnc foam cutting software) | djmrozin | Product Announcements & Manufacturer News | 1 | 03-31-2004 03:14 PM |
| | |
CNC Foam cutting HELP!!! 
Linear Mode
