Smoke and sparks?
Well, looks like I inadvertently stumped the wizards again....I put a hand-copy of the wiring pins for that Isel engraver....and cleared up the text a little....in the thread "Pin out help".
I have not received any response from a couple of other sources, so I guess it is about time to start hooking up wires and see what happens....would not like to fry something, so is there some kind of buffer circuit I could jury rig when I start flipping coins to match wires from the 24Volt controller to the engraver? I'd rather not fry something valuable, but somehow we have to start shoving electrons into this beastie so we can decide if we keep it or sell it....
any ideas to keep damage to a minimum or does it matter too much?
Six wires from the box, making connections to 9 from the motor....eenie meenie mineeee moe.....(gotta quit there..I'm giving away my age....)
KaaaZAAAAPP!! (not with 24 volts, ???)
marc and boyz