| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-24-2003, 10:58 AM
| |||
| |||
I can run my steppers on full , half, or wave mode. I am currently on full step. Is there any advantage to running on wave mode? I really don't understand which is better. Would it give me more speed?    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ametek motors and step down ratio | dowling177 | Servo Motors and Drives | 5 | 03-01-2005 01:24 PM |
| Dirction / Step lines! | bigal | TurboCNC | 2 | 02-06-2005 02:51 PM |
| Help! ...no drive movement | CRFultz | General Electronics Discussion | 4 | 01-21-2005 08:30 PM |
| Choosing a step rate? | Rhodan | General Electronics Discussion | 4 | 04-26-2004 10:42 AM |
| Are all steppers microsteppable? | Greg Fill | General Electronics Discussion | 15 | 04-25-2004 04:57 PM |
| | |
Linear Mode
