| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-27-2003, 12:35 PM
| |||
| |||
Need more help: I just don't understand how to make use of the PWM signal output from Mach2 to control spindle off/on and speed . Mach 2 (on line) text page 31,par 3. " PWM MOTOR CONTROL" states that the PWM signal could be converted to a signal voltage of 0-10 volts , which is a exact match to my DC motor controller that I now control with a potentiometer. can anyone get me pointed in the right direction ?
__________________ cecil    |
|
#2
08-28-2003, 11:11 AM
| ||||
| ||||
| Have you sent the question to Art? He is very good about sending you back an answer.
__________________ Thanks Jeff Davis (HomeCNC) http://www.homecnc.info (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Mach 2 configuration help for Sherline 5410 | wilit | Mach Mill | 14 | 01-15-2010 08:06 AM |
| Mach / geckos or DTLLC drivers | zcases | Mach Software (ArtSoft software) | 3 | 01-11-2007 08:06 PM |
| Mach 2 and settings | tauscnc | Commercial CNC Wood Routers | 4 | 05-25-2005 10:05 AM |
| Mach 2 slow on Intel Centrino P1.6 Notebook | daddyhobby | Mach Software (ArtSoft software) | 7 | 03-28-2005 08:33 AM |
| Proper Computer and Chip for Mach 1 | HomeCNC | Mach Software (ArtSoft software) | 12 | 03-17-2004 10:14 PM |
| | |
Linear Mode
