Change - from linear path control to CNC path control

[fidibus42]

Hi,

I have bought a Maho MH 400P - see following



I would like to have changes - from linear path control to CNC path control


1) Which electronics (Gecko, Rutex, ???) should I use?

2) Which Servo Motor (in each case for the axle X & Y & Z) should I use?

- the Servo Motors are missing



Thank you in advance - Sorry, I am an electronics beginner

Fidibus

PS: The software Mach3 is set

[Al_The_Man]

Do you have three motorized (servo) axis right now? If so you have the motors and amps.
You would need to know however what type of control the amps have analogue/step&dir?
Is there steppers or servo motors.
I assume it is just point to point positioning at present and you want to do interpolated motion?
Depending on the above, You may just need the software.
Al.