Fanuc 6mb moniter replacment????

[mt92]

I have a mid 1980,s burgmaster vtc200 cnc mill that needs a new moniter, is there any way to use a pc screen, or what is the best way to go?
Thanks Mike.

[Al_The_Man]

I have done it on a Fanuc 10 & 11 and some Mazaks, you need to find an older TTL monitor, preferably muli-scan, the ones I found best were made by NEC and TTX model TTX3435P (Colour/mono switchable).
AL.

[mt92]

I am not sure where to get such a moniter, e-bay maybe you think?
Could you let me know how you hooked it up and i might try it.
Thanks Mike

[Al_The_Man]

They sometimes come up on ebay or if you have a obsolete Computer Junk store near you they sometimes have them, The only thing is I dont have the pin out for the 6M I am not sure if it is the same as the 10M.
Al.

[mt92]

If you could would you let me know how you hooked up the 10m and maybe I coud use that for a guide,if not who would know how to do this?
Thanks again Mike.

[Al_The_Man]

Here is the Fanuc hook up from the Honda Plug, you need to find what the respective video, Horiz sync, vert sync and ground connections, if mono screen use the green input if using a colour monitor.
OOps, file too big, I will down size it.
Al.

[mt92]

I will go take a look at the machine and see how close this matches what I have, thans alot for the help, I will let you know what I find.