| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-21-2005, 07:13 PM
| |||
| |||
My stepper motors now are working alright. The only thing is that they are making a "cranking" type noise. Its rather loud, and does not sound good. I am running at 1/8 microstepping. Tried with another motor with the same result, this is happening to all 3 motors so i am pretty sure its something else. ANy ideas would be helpful  |
|
#2
10-21-2005, 07:56 PM
| ||||
| ||||
| what software? what drivers: ball screws? |
|
#3
10-21-2005, 08:01 PM
| |||
| |||
| TurboCNC HobbyCNC 4 axis driver board, these are Unipolar motors with somewhere around 150oz Its an HF Micro mill, ACME screws. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
