Need Help! Referencind Limit switch - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > General Electronics Discussion
Need Help!- Referencind Limit switch

General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here.

This forum is sponsored by:

11-22-2011, 01:14 AM

Join Date: Mar 2009

Location: india

Posts: 42

Referencind Limit switch

permalink

Dear frends,
what is the operating point Reproducibility (repeatability) required for referencing limit switch, used in incremental type servo motor controllers?
currently i am planning to use +/- 0.02 mm repeatability limit switch if it is ok?

regards,
keyan
india

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Limit switch replacement with proximity switch?	Normsthename	Bending, Forging,Extrusion...	3	07-11-2009 10:38 AM
limit switch and home switch setup	Runner4404spd	General Electronics Discussion	0	12-15-2005 07:58 AM
Is it possible to use the home switch as the limit switch as well?	Darc	Mach Software (ArtSoft software)	2	10-23-2005 12:50 AM
Limit Switch / Home Switch in Software	Sanghera	General Electronics Discussion	6	11-01-2004 05:58 PM

All times are GMT -5. The time now is 10:45 PM.