CNC4PC C11 BOB

[accuracymark]

Hi

I have start to gather up my bits and pieces to my next project. Converting an G0704 to a CNC mill. I bought quite a few items from kelinginc.net. some servos etc... One thing that I bought that I am a little confused is the C11 BOB and the C22 interface board for a pendant. How do these boards interface or do they? Is the C22 interface required? As well does any one have a block diagram on the C11 and it relationship with the servo controllers etc.
Brent

[wendtmk]

They don't interface with each other. You'll need two parallel ports. One for the connection between the computer and the C11, and one for the C22 interface.

Mark

[accuracymark]

They don't interface with each other. You'll need two parallel ports. One for the connection between the computer and the C11, and one for the C22 interface.

Mark

Thanks Mark
I am order another parallel port now.
Brent

[wendtmk]

Brent,

You're very much welcome. I use both those items on my machine. Are you running EMC2 or Mach?

Mark

[accuracymark]

Brent,

You're very much welcome. I use both those items on my machine. Are you running EMC2 or Mach?

Mark

I am planning on Mach as I have had it on previous machine. Are you running steppers or servos?

[wendtmk]

Currently running steppers, but I may upgrade to servos in the future.

Mark