| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-27-2011, 06:31 AM
| |||
| |||
I have a 3 phase 220/480 AC motor and the wire numbers are worn of the motor leads. Is it possible to use an OHM meter to figure out whats what?? I found the 3 wye connection leads but then how do i match up 4,5,6, and corasponding leads???  |
|
#2
09-27-2011, 09:13 AM
| ||||
| ||||
|
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with lead screw & motor - 1st build near done | viroy | DIY-CNC Router Table Machines | 105 | 02-19-2010 01:12 PM |
| Running stepper motor wire with router wire? | basskitcase | DIY-CNC Router Table Machines | 2 | 02-19-2010 10:18 AM |
| Problems with motor stalling due to motor/lead screw alignment | Bimmerkc1 | DIY-CNC Router Table Machines | 3 | 01-24-2010 06:12 PM |
| Fanuc Motor Numbers | TR MFG | Fanuc | 8 | 10-27-2009 10:19 AM |
| How to wire an 8 wire stepper motor | technosteve | DIY-CNC Router Table Machines | 1 | 01-16-2009 05:01 PM |
| | |
Linear Mode
