| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-04-2003, 02:47 PM
| |||
| |||
We have a shinx router with sanyo-denki dc servo motors. What are some of the conditions that would continually return a servo error. It isn't always the same axis. We had the control checked out.    |
|
#2
08-04-2003, 10:23 PM
| ||||
| ||||
| Hi Jim, IMO, its either in the motors, the cables, the encoders, the amplifiers or the controller  So what kind of error message are you getting ( in general terms)? Transient errors like that are hard to nail down, but if you have already done the usual swapping of motors, cables and amplifiers, and found no pattern of error, then I'd have to start swapping boards in the controller, if it has any. Failing opto isolators give me grief like that sometimes, but I am not running your particular controller. Sorry I can't be of specific help. 
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Servo Motor Running away. | murphy625 | CamSoft Products | 38 | 02-27-2005 02:08 PM |
| Fadal error codes | HareBall | Fadal | 3 | 01-22-2005 08:52 AM |
| Mixing servo and stepper | ty1295 | Servo Motors and Drives | 0 | 01-19-2005 10:26 AM |
| Need help on Hitachi Seiki error 1012 | anti-SAMS | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 11-24-2004 08:26 PM |
| steppers or servo drives | mmjpotter | Gecko Drives | 14 | 03-30-2004 03:56 PM |
| | |
Linear Mode
