| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-30-2011, 05:02 PM
| |||
| |||
Hi, I have done some research in google and found lots circuit schemes for DIY electronic devices. But I'm wondering is there really enough information out in web to make your own breakboard and motor drivers for DIY CNC router? To be honest with you, I am not good in electronics...not at all but I like DIY stuff and I believe I could make it if there's enough information. I tried to make more PCB's today and they came out quite nice. So my next step would be to learn how to read the circuit board schemes. I know I am bad in it, but I´t's all real interesting and I believe I can make my way if I try. You guys are more experienced in that kind of stuff, what do you think about it? Cheers  |
|
#2
05-30-2011, 05:04 PM
| ||||
| ||||
|
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What electronics? | Michael In Cali | Momus Design CNC plans | 40 | 06-01-2011 02:20 PM |
| what electronics do i need? | yotawheeler | DIY-CNC Router Table Machines | 21 | 12-02-2010 11:19 PM |
| Electronics help | breaksbb | Open Source Controller Boards | 1 | 12-18-2009 09:45 AM |
| I need to know everything about CNC Electronics | alanfreefall | Servo Motors and Drives | 10 | 07-19-2007 08:56 AM |
| Electronics help | chuckknigh | DIY-CNC Router Table Machines | 4 | 07-18-2003 09:09 AM |
| | |
Linear Mode
