| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-20-2011, 11:48 AM
| ||||
| ||||
What are the parallel cable pin/signal requirements to drive the C1 board? I am using EMC2 software to run it and I need to know if it is the Sherline or Xylotex, or some other pin-out setup.
__________________ Allen Louisville KY  |
|
#2
05-22-2011, 08:13 AM
| |||
| |||
| BTS, I don't have any knowledge of the board you are using. If you contact Arturo Duncan at CNC4PC, he can help. He designed that board and is very familiar with operating programs. Arturo will also get back to you quickly. He has even contacted me on the weekends before. JAckal 
__________________ Everything is bio-degradable, if you run over it enough times with the lawnmower. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC4PC C11G BOARD | MegaMoog | Benchtop Machines | 1 | 05-05-2010 03:29 PM |
| Gecko 540 & CNC4PC C6 Board | john1285 | Gecko Drives | 8 | 10-16-2009 02:50 PM |
| CNC4pc C23 breakout board | eloid | General Electronics Discussion | 0 | 02-06-2009 07:49 PM |
| CNC4PC multi board | krymis | General Electronics Discussion | 23 | 07-28-2008 07:49 PM |
| CNC4PC C10 breakout board. | spaceballs_3000 | Benchtop Machines | 3 | 05-02-2008 03:10 PM |
| | |
Linear Mode
