| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-25-2011, 03:06 PM
| |||
| |||
Hi guys, I am in the process of converting over a Bridgeport clone over to CNC. So far we are going to try to use the old AMP cards that were already in there and working with both our companies (Galil and GlenTech). Other than that we are working on wiring everything up and ran into a little problem. In particular to Galil (DCM-21x3) users, how did you wire stuff up from the motion card to the other devices? 37 pin and (4) 15 pin connectors. I am thinking of using a bunch of these CDL4U TERMINAL BLOCK 10-22AWG 35A DOUBLE LEVEL - Seagate Controls Systems, Inc. I am curious what you guys did for your machines. Did you guys have 37-to-37 pin cable to breakout? I am close to  this out.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DC Terminal block or bus bar | DrStein99 | General Electronics Discussion | 2 | 09-21-2009 12:03 PM |
| VFD terminal hook up help | 9 1/2 | Bridgeport and Hardinge Mills | 17 | 01-10-2008 05:46 PM |
| Green Terminal Blocks | krz2_2000 | Bridgeport and Hardinge Mills | 4 | 07-27-2007 03:23 PM |
| Terminal Block | Smackre | General Electronics Discussion | 3 | 11-18-2006 01:34 PM |
| terminal #37 | utengineer04 | Bridgeport and Hardinge Mills | 1 | 09-07-2005 01:40 PM |
| | |
Linear Mode
