| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-25-2011, 04:43 PM
| |||
| |||
Got a PNC Alarm showing on The tuscan at work and im kind of stuck, im only an apprentice so dont know much, but most of us are stuck on this, sure the alarms are ER32 and ER97. Sure there was another alarm saying something like an overide on the Z axis. Anyone got any ideas a what i can check or diagrams on the interent i can print off to help? As im in work tomorrow at 6am it would be great if i could get an answer tonight. Cheers Mick  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What is the status of the Mocca GUI | jbcj | LinuxCNC (formerly EMC2) | 13 | 06-05-2010 04:43 AM |
| How to monitor pin status? | DustToDust | LinuxCNC (formerly EMC2) | 1 | 09-18-2009 11:23 AM |
| Need Help!- status bar mx3 | fenix728 | Mastercam | 6 | 03-25-2009 09:06 PM |
| Rutex status?? | bcromwell | Servo Drives | 6 | 04-08-2008 02:29 PM |
| status bar | miltonmorales | Mastercam | 8 | 02-04-2008 03:56 PM |
| | |
Linear Mode
