| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-05-2011, 10:43 AM
| |||
| |||
Hi Group, Just wanted to let you know I have posted my latest design on my website http://www.avayanelectronics.com. It is for a parallel port interface board which will allow you to drive 5V or 3.3V tolerant stepper drivers. Nothing fancy, just another parallel board to build your CNC in case you are looking for one. I will have bare boards for sale at cost in about 2 weeks in case you want to build your own.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Controller board to Parallel Port. | sac12 | Controller Cards | 0 | 11-19-2009 04:00 PM |
| Parallel Port Breakout Board | BOBINETTE | Stepper Motors and Drives | 0 | 07-03-2009 11:19 PM |
| parallel port or parallel universe | bruno34 | Taig Mills & Lathes | 5 | 04-15-2009 10:58 AM |
| Check this open source board! (TA8435 based, schematic and pcb...but) | patriciooholegu | Open Source Controller Boards | 2 | 12-14-2008 10:36 AM |
| Open Source Controller Board Gallery | pminmo | Open Source Controller Boards | 0 | 11-23-2005 05:02 PM |
| | |
Linear Mode
