Need Help!- Power supply???? please help!

[cncgabe]

I have 6 Ims Mdrive 23 http://www.imshome.com/downloads/man...rod/mdrive.pdf its the md2222-4 i can't figure out what power supply to use to power all 6 or do i need 1 for each motor. if someone could put up a link or a ebay item that would be great or just fill me in on what to look for. I am so lost and i haven't heard back from ims.

thanks in advanced
gabe

[bharbour]

It looks to me like a 32V to 36V unregulated power supply is what you want for the -4 versions of those drivers. The data sheet said 2A continuous, 4A peak per motor, so something in the 18 to 24 Amp range should be good to feed 6 motors. They recommended their own 32V supply, but it varied quite a bit with load current.

This Keling supply http://www.kelinginc.net/KL_3815.pdf should handle 4 of the motors.

Good Luck,
BobH