L298 - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > General Electronics Discussion
L298

General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here.

This forum is sponsored by:

01-02-2011, 07:40 AM

Join Date: Nov 2010

Location: fsd

Posts: 17

L298

permalink

Can I use only L298 to drive stepper motor (unipolar) and what is its rate of frequency?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
L298 temperature	Micro_CNC	Stepper Motors and Drives	0	11-25-2009 10:08 PM
Need Help!- L297 L298 issue	chepot	Stepper Motors and Drives	6	04-21-2009 09:18 AM
Need Help!- l297/l298 with mach3	manmardam	Mach Mill	6	02-01-2009 05:56 AM
3 L298 in Parallel for 5A+	slp_prlzys	Open Source Controller Boards	3	11-04-2007 12:24 PM
ever used 2 l298 in parallel????	ez-cnc.com	General Electronics Discussion	3	06-04-2006 08:39 PM

All times are GMT -5. The time now is 03:30 PM.