| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
07-13-2005, 02:30 PM
| |||
| |||
Here are a few transformers I found. Be careful of the DC volt output, you will burn up the drive if you go higher than recommended. To calculate the approximate DC volt from a transformer multiply AC volts X 1.4 ex: 28vac X 1.4= 39vdc Using a good capacitor or two to help filter it. 28vac, 12amp, $35 http://www.electronicsurplus.com/com...6-6-132859.htm 28vac, 8amp, $25 http://www.electronicsurplus.com/com...-56-4-8016.htm 44vac, 13amp, $25 WARNING: this is about 62vDC !! http://www.electronicsurplus.com/com...942b-39987.htm  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toroidal Transformers | Dan S | General Electronics Discussion | 1 | 09-22-2004 01:44 PM |
| Scavenged Transformers - Amp Rating? | cbcnc | General Electronics Discussion | 13 | 06-29-2004 09:32 PM |
| Is this a goeed/Decent/Bad, Controller | thuffner3 | General Electronics Discussion | 8 | 02-12-2004 09:56 AM |
| Controller good,decent,bad? | thuffner3 | General Electronics Discussion | 0 | 12-17-2003 09:23 PM |
| Ballscrew prices | Kev | DIY-CNC Router Table Machines | 3 | 11-09-2003 09:33 AM |
| | |
Linear Mode
