Perspex case for Sparkfun's version of the Bus Pirate - CNCzone.com-The Largest Machinist Community on the net!

Garfield2 · #1 10-17-2010, 04:30 AM

I thought someone else might find the perspex case I made for my Sparkfun Bus Pirate handy. It's made in three pieces and is designed to allow for small differences in the manufacture of the board.

Any mill with a 0.05 end mill can make it.

Hope someone finds it useful.

You'll find the DXF and EMC2 NC files I used at:
SparkFun Bus Pirate CNC Perspex Case | fromorbit.com

Cheers,
Alan.

epineh · #2 10-17-2010, 06:42 AM

Nice idea, and easy enough to do on any other kind of board that isn't generating heat.

I will bookmark that for some inspiration later on

Russell.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
powermax 45 machine version vs hand version	landmark	Hypertherm Plasma	1	02-14-2010 04:13 PM
Homemade CNC - Plexiglas melts whereas Perspex cuts fine?	HankMcSpank	Glass, Plastic and Stone	7	09-17-2009 07:17 AM
Problem- Pirate Protecting Wizards	Cartesian-xyz	Mach Wizards, Macros, & Addons	8	02-20-2009 11:19 AM
What paint for perspex???	bigz1	Glass, Plastic and Stone	2	07-28-2007 08:47 PM
VCarve Pro Trial version 3.0: any newer version?	monte55	Vectric	2	12-11-2006 05:12 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)