| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-28-2010, 07:41 PM
| |||
| |||
Ac outlet or receptical that hase the 3 prong female insert and is just a square peice of plastic that snaps into a sqare hole you would cut in a a case. looks like this. what is this called? and were can i get one in the US. i thought radio shack but was unable to find it.  Never mind found after 3 hours of searching and then i decide to post and five min after that i figue it out. Can you guess. Its called Snap IN nema 15 receptical  |
|
#2
09-28-2010, 08:46 PM
| |||
| |||
| www.mouser.com http://www.mouser.com/Interconnects/.../?Ns=Pricing|0 Sometimes www.allelectronics.com has them also They also make them with a filter also. |
|
#3
09-28-2010, 08:53 PM
| ||||
| ||||
| If nothing else, get a power strip like this: and scavenge the receptacles.
__________________ Bob "Bad decisions make good stories." |
|
#5
09-29-2010, 06:22 AM
| ||||
| ||||
|
__________________ http://crevicereamer.com Too many PMs. Email me to my name plus At A O L dot com. |
| Sponsored Links |
| |
|
#6
09-29-2010, 08:11 AM
| |||
| |||
|
__________________ Mactec54 |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- I need a very “small part” part catcher | Vern Smith | Haas Lathes | 21 | 08-24-2010 07:55 PM |
| Newb ? - CAD Part interference & mating part dims | pabmartin | Mechanical Calculations/Engineering Design | 3 | 11-06-2009 12:18 AM |
| sheetmetal part? flatten a rolled part? | Rich05 | Solidworks | 1 | 08-12-2009 10:22 PM |
| Newbie- Part holding and milling 3D part on 2.5D Mill? | john_t_h | General Metalwork Discussion | 6 | 03-15-2008 06:35 AM |
| Missing steps on just a certain part of the part | ZipSnipe | Stepper Motors and Drives | 5 | 01-02-2008 01:40 PM |
| | |
Linear Mode
