| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-09-2005, 05:07 PM
| |||
| |||
Hey, Does anyone know which transistors i should use to replace the ones on the site because people posted me and told me that 500mA isn't enough to drive a CNC stepper motor and they are probably right. Thank you in advance for your help. http://www.electronic-circuits-diagrams.com/robotimages/1.gif  |
|
#2
06-09-2005, 05:41 PM
| ||||
| ||||
| Dre, You might want to consider the discrete board at my website: http://pminmo.com/ The circuit you list isn't quite complete to use for cnc software. Look at the opensource forum here at the zone. Phil
__________________ Phil, Still too many interests, too many projects, and not enough time!!!!!!!! Vist my websites - http://pminmo.com & http://millpcbs.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Absolute cheapest Stepper Controller? | samualt | General Electronics Discussion | 14 | 05-25-2007 09:54 AM |
| Taig Mill, US Digital MS23, Controller??? | marjamar | Taig Mills & Lathes | 3 | 02-07-2007 09:16 AM |
| Stepper controller | itsme | General Electronics Discussion | 9 | 08-12-2004 11:30 PM |
| Anyone use this stepper controller? | mvaughn | DIY-CNC Router Table Machines | 0 | 03-18-2004 05:41 PM |
| | |
Linear Mode
