| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-14-2010, 06:38 AM
| |||
| |||
hi i have got a stepper motor(i think it is 12V) from a laser printer. I am thinking to run it through large floppy drive (about 5"), but i think it could not run it with full power. thats why i want to use printer's data pcb board to run it. but i need some guide about pins of data and power connector. plz may you help me. Thanks in advance Asad  |
|
#3
06-17-2010, 06:53 AM
| |||
| |||
| I also have try to run 6 wire motor with small floppy drive and it only run buildin motor. I think it generate low powered pulses. is there any way to powering up current coming to wires of motor. pic of my motor is attached |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stepper motor data for 4H5618S-69 | Zeljkoc | Stepper Motors and Drives | 0 | 03-18-2010 03:15 PM |
| Vexta Stepper Motor Data Request... | scuba840 | Stepper Motors and Drives | 1 | 08-14-2008 02:24 PM |
| Need Help!- Stepper Motor data needed | leitox | Stepper Motors and Drives | 2 | 06-06-2008 02:22 PM |
| stepper motor of a printer & driver card | sting | Mach Software (ArtSoft software) | 0 | 04-17-2007 04:04 AM |
| Printer Stepper Motor | venomx999 | Mechanical Calculations/Engineering Design | 20 | 12-03-2005 06:15 PM |
| | |
Linear Mode
