Results 1 to 2 of 2

Thread: what are these babies called?

  1. #1
    Registered
    Join Date
    Feb 2006
    Location
    england
    Posts
    64
    Downloads
    0
    Uploads
    0

    what are these babies called?



    I couldn't find any hence the sketch. My matsuura had these soft clear rubber[silicone?] boot's over ring terminals that were bolted together. I have searched all the cable management and terminal sites I can find and not come across anything like them.


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    19110
    Downloads
    0
    Uploads
    0
    I have seen them advertised in one of the industrial heatshrink suppliers catalogue, I forget which now, if I come across it I will post it.
    It could be either Panduit or Raychem?
    Al.
    CNC, Mechatronics Integration and Custom Machine Design (Skype Avail).

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


Similar Threads

  1. wHAT IS IT CALLED ?
    By Zirok in forum Mechanical Calculations/Engineering Design
    Replies: 36
    Last Post: 06-10-2010, 01:00 PM
  2. What is this tool called?
    By jkittle99 in forum General Metalwork Discussion
    Replies: 2
    Last Post: 05-04-2009, 12:10 AM
  3. New Machine Build- What are these called?
    By Steve Crum in forum Stepper Motors and Drives
    Replies: 3
    Last Post: 07-05-2008, 01:41 AM
  4. What is this called and where can I order it?
    By Alex_Cole in forum Benchtop Machines
    Replies: 2
    Last Post: 01-23-2007, 06:46 AM
  5. What are they called
    By Rhodan in forum CNCzone Club House
    Replies: 5
    Last Post: 08-23-2006, 01:29 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.