| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-22-2010, 08:43 AM
| |||
| |||
I think I want to buy a Colombo spindle. Has anyone wired this up to a Gecko 540? I looked through the manuals and I'm not clear how to connect the two units. The Gecko has three terminals for the VFD. Pin 7 is the VFD ground Pin 8 is VFD output Pin 9 is +10V. Is pin 9 (+10V) a input or output? What pins on the VFD do I connect these to? The VFD has the following terminals: +10V AVI ACI AUI ACM Thanks,  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C11G, Gecko 203v and Mach 3...connect what where? | teamtexas | Gecko Drives | 16 | 12-03-2009 09:53 PM |
| Need Help!- need help on a Colombo spindle | contactirfu | Phase Converters and VFD | 2 | 09-02-2009 07:33 PM |
| $500 3HP Colombo Spindle Upgrade | blurrycustoms | Product Announcements & Manufacturer News | 1 | 07-22-2009 10:32 AM |
| 3HP Colombo Router Spindle + VFD for under $2k | blurrycustoms | Product Announcements & Manufacturer News | 8 | 06-09-2009 09:59 AM |
| Colombo Spindle wiring | powerfade | General Electronics Discussion | 1 | 09-20-2007 02:13 PM |
| | |
Linear Mode
