| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-12-2010, 08:43 AM
| ||||
| ||||
dear friends, I have TA8435H 5 axis driver board with spindle connector on it. but spindle connector has 3 outputs. M4, M- and GND. as I understood mach3 sontrols spindle somehow like stepper motors. I need information to control my spindle (standard dremel motor). I actually just meed to open and close a relay with mach3 but I could not succeeded. simple circuits or any documents would be great.This driver board has not enough documentation. best regards.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mach3 spindle control on nm-200 | urbanimports02 | Novakon Systems | 2 | 01-19-2010 09:33 AM |
| Need Help!- Spindle Control Problem in Mach3 | creativecad | Mach Software (ArtSoft software) | 4 | 08-06-2009 06:57 PM |
| VSD-A Spindle control in MACH3? | mkuivamaki | Granite Devices | 8 | 09-08-2008 02:09 PM |
| SX3 spindle speed control with Mach3 | bbox | Benchtop Machines | 47 | 07-05-2008 05:15 PM |
| | |
Linear Mode
