| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-04-2005, 02:38 AM
| |||
| |||
i have a 2 amp camtronic driver board by dan mauch. the y and z axis both work when i jog the axis in desknc. the magnetic break works on all 3 axis. i am useing a demo of desknc. when i swap the x axis l297 chip to y or z axis they still work. when i swap them back y or z axis still work i have also swapped the 74hct123 and cd4066 from the x axis to the z and y axis with the same result y and z work x axis does not. i have continuity from parallel port to step direction pins on l297. dose any one have any ideas?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with 2 Amp, Camtronics Board. | Willyb | Stepper Motors and Drives | 7 | 02-03-2006 10:20 PM |
| 2 amp camtronics board working | gearcut | Stepper Motors and Drives | 0 | 05-10-2005 10:40 PM |
| 2 amp camtronics board | gearcut | Stepper Motors and Drives | 0 | 05-04-2005 10:21 PM |
| fet 3 15 amp 3 axis driver board (stepperworld) | mike10 | Stepper Motors and Drives | 17 | 04-29-2005 10:30 PM |
| High amp driver board | jimglass | General Electronics Discussion | 1 | 04-09-2003 08:46 PM |
| | |
2 amp camtronics board 
Linear Mode
