| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
04-30-2005, 11:44 AM
| |||
| |||
Hi Group I have a problem with my x and y axis moving when the power is turned on to the geckos. This occurs before any g-code is run. I have the 470 cap wired to the power terminals of the geckos. I thought this might solve the problem but that does not seem to be the case. I`m using the G210 Geckos Thanks  |
|
#2
04-30-2005, 12:08 PM
| ||||
| ||||
| Is this with the control software running? The control software should be running before power is applied to the Geckos. If the software is running, then it sound like you may have noise on your step and direction lines.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A little help hooking up Geckos please | foamcutter | Gecko Drives | 2 | 01-26-2010 05:53 PM |
| Gecko's faulting | dowling177 | Gecko Drives | 2 | 04-08-2005 02:02 PM |
| Turbo CNC and geckos | snoman70 | TurboCNC | 9 | 03-30-2005 06:47 AM |
| Gecko's vs. all-in-one controller | dowling177 | Gecko Drives | 6 | 02-13-2005 05:06 PM |
| Power Supply for gecko's | drakesis | Gecko Drives | 1 | 02-06-2005 10:13 PM |
| | |
Linear Mode
