My geckos have a mind of their own

[bgolash]

Hi Group

I have a problem with my x and y axis moving when
the power is turned on to the geckos. This occurs before
any g-code is run. I have the 470 cap wired to the power
terminals of the geckos. I thought this might solve the
problem but that does not seem to be the case. I`m using
the G210 Geckos


Thanks

[ger21]

Is this with the control software running? The control software should be running before power is applied to the Geckos. If the software is running, then it sound like you may have noise on your step and direction lines.