| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General Electronics Discussion Discuss basic electronics, power supplies and anything else electronic related here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-20-2010, 10:33 PM
| ||||
| ||||
Does anyone know of a DIY circuit that will interface a HEDS-9100 to Mach3? I already have the HEDS-9100 and code-wheels with .250 shaft. I have a router setup with steppers but I was thinking of adding the encoders as a monitor only and stop the router if the stepper looses steps for any reason. I figured to use the encoders for something...  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2.0 GHz / 512 MB Ram / 128 MB AGP ok for Mach3? | samim | Machines running Mach Software | 4 | 06-07-2009 11:45 AM |
| Problem- G320 + HEDS-5540(encoder)? | Vrogy | Gecko Drives | 5 | 06-04-2009 03:04 PM |
| Looking for info on HEDS-5310 encoder | tphillips | Servo Motors and Drives | 10 | 12-06-2007 04:56 AM |
| Need info on HEDS-6300 encoder. Sorta... | Fifty_ohm | General Electronics Discussion | 0 | 12-14-2006 07:31 PM |
| HEDS-9100 encoder modul | giorgiocnc | General Electronics Discussion | 4 | 09-11-2006 03:04 AM |
| | |
Linear Mode
